Voron Mgn12 Mod. One fixed to be used on the voron v2.4 or v1.8 ab with mgn12 or mgn9. For any voron stock parts, or the z idlers, please use standard voron settings.
For any voron stock parts, or the z idlers, please use standard voron settings. The design is easily enclosed and has a lighter moving mass which sets it up for high speed prints with beautiful parts. Highly repeatable and accurate probes.
0.3mm layer height, 2 perimeters, 2 bottom, 3 top, 20% infill. Highly repeatable and accurate probes. Recommended addition to the voron 2.4 sourcing guide tab.
The design is easily enclosed and has a lighter moving mass which sets it up for high speed prints with beautiful parts. All extrusions are listed using misumi part numbers. Part numbers are listed for both square 4040, and rounded 404020 vertical extrusions.
For skirts, etc, you may use other settings to reduce filament usage. The sourcing guide link (v2.4 tab, line 73) for a bowden fitting goes to the embedded bowden fitting as used in jetpack, rather than the threaded one used in the v2.4 exhaust assembly. While the v2 is a great machine it’s probably not the best for.
The voron v2.4 is a light weight and compact corexy motion system with a superior design. Category component qty recommended alternative source;
Comments
Post a Comment